Nilfisk-ALTO NEPTUNE 4 FA Operating Instructions Manual page 14

NEPTUNE 4 FA
5.2.2 Vehicle
Task
Vehicle bodywork
5.2.3 Buildings and Equipment
Task
General surfaces
Metallic equipment
Rusted or dam-
ages surfaces prior
to treatment
These are merely several examples of cleaning tasks that can be solved by a pressure washer in asso-
ciation with accessories and detergents. Each cleaning task is different. Please consult your local dealer
or ALTO representative in order to discuss the best solution for your own cleaning tasks.
12
Accessories
Standard lance
Detergent injection
Curved lances and un-
derchassis washers
brushes
Detergents
Active Shampoo
Active Foam
Sapphire
Super Plus
Active Wax
Allosil
RimTop
Accessories
Foam injectors Stand-
ard lance
Curved lances
Tank cleaning
head
Detergents
Intensive
J25 Multi
Combi Active
Alkafoam
Disinfectant
DES 3000
Wet Sandblasting
equipment
Method
1. Apply detergent to vehicle or equipment surfaces in
order to soften up dirt and grime. Apply from bottom
to top. In cases of particularly dirty vehicles, pre-spray
with a product such as Allosil in order to remove traces
of insects etc, then rinse at low pressure and apply
normal car cleaning detergent. Let detergents settle
for 5 minutes before cleaning off. Metallic surfaces can
be cleaned using RimTop.
2. Proceed with cleaning using the high pressure lance.
Clean again from bottom to top. Use accessories to
clean in difficult to reach places. Use brushes in order
to add a mechanical cleaning effect. Short lances can
help for cleaning of motors and wheel arches. Curved
lances or undercarriage washers can be valuable for
the cleaning of car underchassis and wheel arches.
3. Clean fragile areas such as motors, rubber at lower
pressure levels to avoid damage.
4. Apply a liquid wax using the pressure washer in order
to protect the bodywork from pollution.
Method
1. Apply thick foam over the surfaces to be cleaned. Apply
on dry surfaces. Apply from top to bottom on vertical
surfaces. Let the foam act for up to 30 minutes for the
optimal effect.
2. Proceed with cleaning using the high pressure lance.
Use applicable accessories. Use high pressure to
dislodge large amounts of incrusted dirt or grime.
Use lower pressure and high water volume in order
to rapidly flush away loose dirt and rinse surfaces.
3. Apply DES 3000 disinfectant once the surfaces are
perfectly clean.
Areas covered by amounts of loose dirt, such as animal
remains in slaughterhouses, can be removed by using
high water flow to flush away the dirt to evacuation pits
or drains.
Tank cleaning heads can be used to clean barrels, vats,
mixing tanks etc. Cleaning heads may be hydraulically or
electrically powered and give the possibility for automatic
cleaning without a constant user.
1. Connect the sandblasting lance to the pressure
washer and place the suction tube in the sand.
2. Always wear protective equipment during sandblast-
ing.
3. Spray the surfaces to be treated with the mix of water
and sand. Rust, paint etc will be stripped off.
Options / model variants
1)
Original instructions