How To Adjust Radio Frequency Of Microphone; How To Turn On/Off Microphone; How To Interchange Microphone Head - Better Music Builder VM-62U Operating Instructions Manual

HOW TO ADJUST RADIO FREQUENCY OF MICROPHONE

Adjust the signal of the radio frequency using the RF switch on the handheld
microphone. Switch to High (10mW) to use a stronger signal and Low (5mW)
to use a weaker signal. However, the drawback of using a stronger signal is
the increased chance of interference.
090
VM-62U
UHF WIRELESS SYSTEM
CH
FREQUENCY: 520~682 MHz
662.500
BATTERY SIZE: 2AA
MHz Engineered in U.S.A. FCC

HOW TO TURN ON/OFF MICROPHONE

TURN ON: Push the power switch up to turn microphone's power ON.
Microphone's LED screen will displays Frequency, Channel, Radio Frequency
and Battery Status.
TURN OFF: Push the power switch down to turn microphone's power OFF.
Microphone's LED screen will be off.
After turning on the microphone's power on, there might be a need to adjust
the frequency to match the receiver's frequency.
If the microphone cannot be turn on, please check the battery. It may be very low.
NOTE
Typical new full battery life is 4~6 hours with our system, otherwise, the batteries might be
defective or near expiration date.

HOW TO INTERCHANGE MICROPHONE HEAD

1
H
L
2
INTERCHANGEABLE
MICROPHONE HEAD
662. 5 00
RF
NOTE
Replacement parts (such as the
microphone head as shown on the
left) can be purchased from any of
our authorized dealers.
13
090
CH
MHz