Battery Charging; Battery Indicator While Charging - 909 CD142L Instruction Manual

Battery charging

IMPORTANT.
Before plugging in the power supply from the
charger adaptor (9) to the charger base (10) always ensure
that the plug is switched off at the mains.
IMPORTANT. The battery will be fully charged after approx
3-5 hours, remove it from the charger after this time.
Do not leave a battery charging for longer than 24 hours.
1. Align the battery pack (5) with
the charger base (10) as per
the picture shown. Insert the
battery pack (5) and slide it
firmly into position as shown.
Note: If the battery pack is
incorrectly orientated the battery
will not fully enter the base as
depicted.

Battery indicator while charging

Status Red
LED
ON
Charging
Fully OFF
charged
High
OFF
temperature
or defective
Battery
OFF
conditioning
or defective
Yellow Green Charging status/indicator description
LED LED
FLASH FLASH Yellow and green LED lights flash one after the other during the 3 – 5 hour
charging duration
OFF ON
Battery pack is fully charged
High temperature. The battery pack temperature is too high and needs
to be cooled down. Once the battery pack has been cooled down to an
appropriate level the battery will continue to charge.
ON OFF
If the battery pack cools down and the status remains unchanged then
the battery pack is defective/damaged and should not be used.
WARNING:
Battery conditioning occurs when the battery pack has low charge left in
its cells. It may take around 90 minutes for the battery to be conditioned
before commencing the charging process.
OFF OFF
If the status remains unchanged then the battery pack is defective/
damaged and should not be used.
WARNING:
2. Connect the power supply
from the charger adaptor (9)
to the charger base (10) via
plugging the socket from the
charger adaptor (9) into the
side of the charger base (10)
housing.
3. Plug in the charger and switch
on at the power supply. The
red LED indicator located on the charger base (10) will
indicate that the charger base has power connected to it.
The flashing lights on the battery pack will indicate the
battery status while the battery is charging. Refer to the
below table:
Never use a damaged battery pack.
Never use a damaged battery pack.
11