Waeco IU152A Installation And Operating Manual page 45

_PerfectCharge_IU152A-IU802A.book Seite 45 Dienstag, 15. September 2009 5:19 17
PerfectCharge
Observe the following safety instruction for the electrical connections:
Caution, risk of short circuit
e
Always use sockets which are grounded and secured by resid-
ual current circuit breakers.
If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
Do not lay cables which are loose or bent next to electrically
conductive material (metal).
Fasten the cables securely.
Do not pull on the cables.
Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
Lay the cables so that they cannot be tripped over or damaged.
9.1 Connecting the IU0U automatic charger to a battery
(fig. 8, page 7)
Warning
d
Avoid coming into contact with the battery fluid.
Caution
e
Batteries with a cell short circuit may not be charged, as explosive
gases may form due to overheating of the battery.
Note
a
Loose connections may cause overheating.
Tighten the screws on the terminals to a torque of 12 – 13 Nm.
Note
I
IU152A: To connect starter batteries, use the special "START
BATT +" terminal intended for this purpose.
Note
I
IU154A, IU252A: To connect starter batteries, use the special
"BATT 1+" terminal intended for this purpose.
Connecting the IU0U automatic charger
45