Faults - Kärcher B 60 W Ep Operator's Manual

DANGER
Risk of injury! Turn the programme selector
switch to "OFF" and disconnect the mains
plug prior to performing any work on the de-
vice.
 Drain and dispose of the dirt water and
the residual fresh water.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Fault
Appliance cannot be started
Insufficient water quantity
Insufficient vacuum performance Clean the seals between waste water tank and cover and check for tightness, replace if required.
Insufficient cleaning result
Brushes do not turn
Vibrations during cleaning
16
Remedy
Insert the mains plug into a socket.
Check power supply of the socket.
Check fresh water level, refill tank if necessary.
Increase the water volume on the regulating knob for water volume.
Unscrew the lock of the fresh water reservoir. Remove and clean the fresh water filter. Insert the filter
and screw in the lock.
Remove the water distribution strip from the cleaning head and clean water canal (only R cleaning
head).
Check hoses for blockages; clean if required.
Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir
Clean the fluff filter.
Clean the vacuum lips on the vacuum bar, replace if required
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Check the brushes for wear, replace if required.
Check if foreign matters block the brushes; remove foreign matter if required.
Reset fuse of brush drive.
You might need to use softer brushes.

Faults

6
-
EN