Faults - Kärcher BR 35/12 C Bp Original Instructions Manual

Danger
Risk of injury. Turn the appliance switch to
"0" and pull the mains plug of the charger
prior to performing any work on the appli-
ance.
Fault
Appliance cannot be started
Insufficient water quantity
Insufficient vacuum perfor-
mance
Insufficient cleaning result
Brush does not turn

Faults

Risk of damage to the appliance on ac-
count of water leakage. Drain out dirty wa-
ter and the remaining free water before
working at the machine.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Remedy
Switch on the appliance switch, wait 3 seconds, check
charge condition of the battery.
Check fresh water level, refill tank if necessary.
Switch on "Detergent" button.
Open the dosing device for the cleaning solution.
Clean the fresh water filter.
Lower the vacuum bar.
Empty the dirt water reservoir.
Clean the seals between dirt water reservoir and cover
and check for tightness, replace if required.
Clean the vacuum lips on the vacuum bar, turn or replace
if required
Check if the suction hose and vacuum bar are chocked,
clean if required
Check the suction hose for tightness; replace if required.
Check/set the brush contact pressure.
Check the brush type and the detergent for their suitability.
Check the brushes for wear, replace if required.
Pull the safety switch towards the steering wheel.
Check if foreign matters are blocking the brush roller; re-
move foreign matter if required.
Switch off the switch for the brush drive, wait for a short
period of time, switch the switch back on.
– 9
EN
Warning
11