Registering A Unit; Additional Handsets; Additional Base Units - Panasonic KX-PRS120AZ Operating Instructions Manual

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to a single
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations may not be
available.

Additional base units

Handsets can be registered to up to 4 base
units, allowing you to add additional base units
and extend the area in which your handset(s)
can be used. If a handset moves out of range
of its base unit when "Auto" is selected on
base unit (page 33), it looks for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is
called a "radio cell".
Note:
R Calls are disconnected when the handset
moves from one radio cell to another.
Registering a handset to a base
unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
MMenuN (right soft key) #130
2
MbN: Select a base unit number. a MOKN
R This number is used by the handset as
a reference only.
3
Base unit:
Press and hold M
R If all registered handsets start ringing,
press M N again to stop, then repeat
this step.
PRS120AZ(en)_0724_ver012.pdf PRS120AZ(en)_0724_ver012.pdf
4
Selecting a base unit
When "Auto" is selected, the handset
automatically uses any available base unit it is
registered to. When a specific base unit is
selected, the handset makes and receives
calls using that base unit only. If the handset is
out of range of that base unit, no calls can be
made.
1
2
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
2
3
4
Cancelling a base unit
A handset can cancel a base unit that it is
registered to. This allows the base unit to end
its wireless connection with the system.
1
2
3
N for about 5 seconds.
33 33
Programming
Handset:
MOKN a Wait until "Base PIN" is
displayed. a Enter the base unit PIN
(default: "0000"). a MOKN
R If you forget your PIN, contact an
authorised service centre.
MMenuN (right soft key) #137
MbN: Select the desired base unit number,
or "Auto". a MOKN
MMenuN (right soft key) #131
R All handsets registered to the base unit
are displayed.
MbN: Select the handset you want to
cancel. a MOKN
MbN: "Yes" a MOKN
M N
MMenuN (right soft key) #139
MbN: Select the base unit you want to
cancel. a MOKN
MbN: "Yes" a MOKN a M
2013/07/24 2013/07/24 11:29:10 11:29:10
N
33