Volume Adjustment And Forced Mono - Metz 72 TF 80, 72 TF 81, 72 TF 82, 72 TF 83, 72 TF 86, 72 TF 88, 84 TF 88, 72 TF 89 Operating Instructions Manual

6. Volume adjustment and forced mono

It is possible for TV stations to be received at different volume levels although the volume level settings on the individual programme
positions are identical. To overcome this problem, you can set a volume correction factor for each programme position.
Example:
Programme 1 is soft: volume value 40. Programme 3 is loud: volume value 40. Programme 1 is to be adjusted to the same volume as
Switch over to programme position 1.
Programme 3.
Press this key on the remote
control....
1. Call the sound submenu
and adjust the volume
white
red
yellow
-
2. Set forced mono
yellow
-
3. Store the setting and return
to TV picture
OK
TV
22
The screen displays
return picture
TV
MENU
TV station table
Programme Pict. Sound
LM
0 LOGIC
— —
1 ARD — —
2 ZDF
— —
3 SAT 1 — —
4
Volume adjustment
5
Forced mono
6
7
8
9
<< weitere Einstellungen
Logo, Channel, Signal
696+06A-GB
store ?
return picture
TV
MENU
TV station table
Programme Pict. Sound
LM
0 LOGIC — —
1
ARD — —
2 ZDF — —
3
SAT 1 — —
4
5
Volume adjustment
6
Forced mono
7
8
9
<< weitere Einstellungen
Logo, Channel, Signal
6 9 6 + 0 6 B - G B
store ?
In this submenu, you can assign a volume correction
Help
?
factor to a programme position and, if necessary,
activate forced mono sound mode.
Std
A volume correction factor can be set with the
Auto. when the text is displayed on a blue background.
Auto.
Auto.
Press the
Auto.
Auto.
which is added to the standard volume value (increa-
+00
Auto.
Off
Auto.
sing the volume). Press the
Auto.
correction factor which is subtracted from the
Auto.
Auto.
standard volume value (decreasing the volume).
In our example:
Press the
OK
same as the volume on Programme 3. The resulting
correction factor could , for example, be displayed as 05.
It may happen that the TV set inadvertently switches
Help
?
from mono to stereo during a transmission,
although no stereo programme is being received.
This usually depends upon the prevailing reception
Std
conditions.
Auto.
Auto.
Auto.
Use the -
Auto.
Auto.
Auto. If this setting is stored, all transmissions received in
+00
Auto.
Off
this programme position will always be reproduced in
Auto.
Auto.
mono.
Auto.
OK
All changed settings are stored.
Explanation
key to enter a positive correction factor
-
key to enter a negative
key and increase the volume until it is the
keys to select forced mono.
- keys