Front Panel - Toshiba Portege R300 Maintenance Manual

4 Replacement Procedures

4.17 Front panel

Removing the Front panel
To remove the front panel, follow the steps below and refer to Figure 4-27.
1. Disconnect the LED cable to the connector CN9510 on the LED board.
2. Peel the glass tape.
3. Disconnect the speaker cable to the connector CN6350 on the system board.
4. Disconnect the microphone cable to the connector CN6050 on the system board.
5. Lift up the front panel and remove the front panel.
CN6050
Installing the Front panel
To install the front panel, follow the steps below and refer to Figure 4-27.
1. Install the front panel to the base assembly.
2. Connect the microphone cable to the connector CN6050 on the system board.
3. Connect the speaker cable to the connector CN6350 on the system board.
4. Use the glass tape to affix the speaker cable to the base assembly while pulling, so
that the speaker cables does not come loose.).
5. Connect the LED cable to the connector CN9510 on the LED board.
4-36 [CONFIDENTIAL]
Speaker cable
Glass tape
CN6350
Figure 4-27 Removing the Front panel
Microphone cable

Front panel

CN9510
PORTÉGÉ R300 Maintenance Manual (960-591)
4.17 Front panel
LED cable