Table of Contents
Advertisement
4 Replacement Procedures
Installing the HDD (only 1.8" HDD model)
To install the HDD, follow the steps below and refer to Figure 4-22 and Figure 4-23.
1. Install the HDD cap to the HDD.
2. Connect the HDD cable to the HDD.
3. Install the HDD to the base assembly.
Use a jig if it is difficult to install the HDD.
4. Connect the HDD cable to the connector CN1800 on the system board.
Removing the HDD (only 2.5" HDD model)
To remove the HDD, follow the steps below and refer to Figure 4-22 and Figure 4-24.
NOTE: The following steps describe how to disassemble the HDD assembly; however, do
not disassemble if the HDD is working properly.
1. Disconnect the HDD cable from the connector CN1850 on the system board.
2. Lift up the HDD assembly.
3. Place the HDD assembly on a flat surface, and remove the following screws.
• M3×4S
4. Separate the HDD and HDD bracket.
5. Disconnect the HDD cable from the HDD.
4-32
[CONFIDENTIAL]
FLAT HEAD screw
×4
PORTÉGÉ R300 Maintenance Manual (960-591)
4.15 HDD
Advertisement
Table of Contents
Troubleshooting
