Furuno FCV-628 Operator's Manual page 55

4. INSTALLATION
Transducer
If you have the transducer 525STID-MSD or
525STID-PWD, skip this procedure.
1. Select [Type] from the [Installation] menu,
then press the ENTER key.
FCV-588
2. Select your transducer, then press the
ENTER key.
Select [600W] for the 600 W transducer,
[1kW] for the 1 kW transducer, not listed
in the following table.
Transducer (option)
600 W 520-5PSD, 520-5MSD, 520-PLD,
525-5PWD, 525T-PWD, 525T-BSD,
525T-LTD/12, 525T-LTD/20,
525STID-MSD, 525STID-PWD,
SS60-SLTD/12, SS60-SLTD/20
1 kW 50/200-1T, 526TID-HDD
Note: Do not use a 600W transducer in
the 1kW setting. The transducer will be
damaged.
3. Press the MENU/ESC key to finish.
If you have the Tankenmaru system, go to the
next section. To set up external equipment,
go to "NMEA".
Tankenmaru
The Tankenmaru system outputs the video
signal from your fish finder to a Tankenmaru-
equipped display device, via a radio transmit-
ter. The radio transmitter and display device
are products of the Shimano Corporation. For
how to install the Tankenmaru unit see its in-
stallation manual.
FCV-628
48
1. Select [Tankenmaru System] from the In-
stallation menu, then press the ENTER
key.
2. Select [On], then press the ENTER key to
activate the Tankenmaru system. The
[System] menu changes as below.
[Off] selected
(Std. spec.)
3. Press the MENU/ESC key to finish.
NMEA
The NMEA port is disabled when the Tanken-
maru is active.
1. Press the MENU/ESC key.
2. Select [NMEA] from the Installation
menu, then press the ENTER key.
Set the menu items according to the equip-
ment connected to the fish finder.
[NMEA0183]: Select NMEA0183 version of
nav equipment connected to "12-24 VDC/
NMEA" port among [Ver 1.5], [Ver 2.0] and
[Ver 3.0].
Tankenmaru
[On] selected
(Tankenmaru spec.)