Configuring The Connection; Using Ad Hoc Mode - Epson PowerLite 7850p User Manual

note
Make sure you've installed
the NS Connection software
as described in Appendix A.
Presenting Through a Wireless Network
70

Configuring the Connection

You can use NS Connection to connect to the projector and send
images wirelessly in two modes: Ad Hoc mode or Access Point mode.
Ad Hoc mode lets you connect just one PC or laptop to the
■
projector at a time; it's easy to set up, and the only equipment you
need is a computer with a wireless (802.11b) network card.
■ Access Point mode (or infrastructure mode) lets multiple users
access the projector at the same time and easily trade off control
over the projector. To use Access Point mode, you need a wireless
(802.11b) access point and one or more computers with built-in
wireless network cards.
Follow the correct instructions below for the mode you want to use.

Using Ad Hoc Mode

In order to use Ad Hoc mode, first adjust your projector and network
card settings as described in this section.
Configuring the Projector
To configure the projector for Ad Hoc mode, make sure you've
switched it to EasyMP and inserted the network card (see page 68).
Then follow these steps:
1. On the EasyMP Network Screen, the
highlighted as shown below.
button is already
Config
Config button