Epson PowerLite 7850p User Manual page 80

note
For instructions on how to
access the Access Point mode
advanced settings screen, see
page 76.
note
Text input for WEP
encryption varies with
different access points; check
with your network
administrator. Try
Text1
first. If that doesn't work,
try and then
Text2 Text3
note
To enter numbers with the
remote control, press the
button. When it lights
Num
up, numeric keypad mode is
active. Press the
Num
button again to exit numeric
keypad mode.
Presenting Through a Wireless Network
80
Adding WEP Encryption
When you click the
settings screen, you see this screen:
1. If you want to enable WEP encryption, highlight either
for 128 bit WEP encryption, or
Then press
Enter
2. For Format, select the input system for the WEP encryption key.
Highlight
HEX
options to enable text input. Then press
3. For Key ID, leave this setting at
encryption. If you're using 40 bit WEP encryption, highlight any
.
of the options and press
4. Highlight the
cursor turns green to indicate you are in input mode. Check with
your network administrator for directions on entering a key for
your network, and follow these general guidelines:
For 128 bit WEP encryption with hexadecimal input, enter
■
up to 26 single-byte characters, from 0 to 9 and from A to F.
For 40 bit WEP encryption with hexadecimal input, enter up
■
to 10 single-byte characters, from 0 to 9 and from A to F.
button on the Access Point mode advanced
WEP
40Bit
.
to enable hexadecimal input, or one of the
if you're using 128 bit WEP
0
.
Enter
text box and press
Encryption key
128Bit
for 40 bit WEP encryption.
Text
.
Enter
. The
Enter