Epson PowerLite 7850p User Manual page 79

8. If your access point assigns IP addresses automatically, turn on
. Otherwise, turn off DHCP and enter the following
DHCP
information manually:
■ : Type in the IP address you want to assign to the
IP address
projector. It must be formatted like other addresses on the
network; usually the first three numbers (XXX.XXX.XXX)
match the access point's IP address.
■
Subnet mask
depends on how your network is set up.
■
Gateway address
the access point when it was set up.
9. If you want to monitor the projector using HP OpenView,
you'll need to enter at least one trap IP address. See Chapter 7 for
details on monitoring the projector.
10. If you want to set up WEP encryption on the projector for
additional security of wireless transmissions, click the
button on the left side of the screen and continue with "Adding
WEP Encryption" below. Otherwise, continue with step 11.
11. When done making your settings, highlight the
top of the screen (you can either use the
control or press
ESC
the button again and press
OK
EasyMP Network Screen. Then continue with "Configuring the
Network Settings on Your Laptop or PC" on page 81.
: For example: 255.255.255.000, but this
: Enter the IP address that was assigned to
to highlight it), then press
to return to the main
Enter
™
WEP
button at the
OK
button on the remote
. Highlight
Enter
Presenting Through a Wireless Network
note
For specific details about
your network, please consult
your network administrator.
If you don't know your
gateway or access point
address, see page 85.
79