Recommended Naída Ci Q90 Operating And Storage Temperatures; Approved Power Sources; Troubleshooting The Naída Ci Q90 - ab Naida CI Q90 User Manual

Recommended Naída CI Q90 Operating and Storage Temperatures
Operating and Storage Temperature Ranges
Condition
Operating temperature
Storage temperature

Approved Power Sources

Advanced Bionics has verified the Naída CI Q90 to function with the power sources listed
below; behavior when using power sources other than those listed here cannot be guaranteed.
Approved Naída CI Q90 Power Sources
Power Source
PowerCel Mini
Programming Interface
(used during fitting, only)
Approved Naída CI Q90 Power Supplies
Power Supply
PowerCel
Zn-Air
Programming Interface
Troubleshooting the Naída CI Q90
If no sound is heard or the red LED is flashing once per second on the Naída CI Q90 processor
LED when the headpiece is in place over the implant, try the following troubleshooting steps:
Visually inspect the cable for any damage or breakage and verify it is firmly attached to
1
the headpiece and sound processor.
Remove any materials (hat, scarf, headband, etc.) that may be covering the microphone.
2
Unaided listeners may perform a listening check of the microphones as described in the
3
Listening to the Microphone and Auxiliary Input
PowerCel
Zn-Air
Rated Voltage
3.7 V
2.8 V
5.0 V
Minimum
0°C (32°F)
-20°C (-4°F)
Type
Li-ion (Rechargeable)
Zn-Air (Disposable)
DC
section of the User Guide.
Naída CI Q90 Sound Processor User Guide
Maximum
45°C (115°F)
55°C (131°F)
Capacity (mAhr)
110
170
230
110
170
1,140
Not Applicable
Rated Energy
0.4 Wh – 0.9 Wh
1,240 mWh
1,250 mW
55