Removing The T-Mic 2/Earhook - ab Naida CI Q90 User Manual

Pull the tool away from the processor,
leaving the pin inside the Naída CI.

Removing the T-Mic 2/Earhook

Remove the power source. Align the
pointed end of the T-Mic 2/Earhook
tool with the hole on the processor that
contains the pin holding the T-Mic 2/
Earhook on the Naída CI processor.
The pin does not need to be fully
removed from the processor. As long
as the tool was pushed in flush on one
side of the processor, the pin should
be displaced enough for the T-Mic 2/
Earhook to be removed.
20
Naída CI Q90 Sound Processor User Guide
5
1
3
2
Gently press the tool in the hole, pushing
the pin out the other side.
4
Remove the tool from the Naída CI.
Gently grasp the T-Mic 2/Earhook at
the top near where it connects with the
processor and pull forward, until it is
separated from the processor.