Table of Contents
Advertisement
C
ONNECTION OF A
1.
If the PC is on, exit your application and turn the PC off.
2.
Disconnect the keyboard from the PC. Plug the Keyboard Wedge cable to
the PC and the keyboard. Use the adapter cable if necessary.
3.
Connect the 25-pin D-type connector on the scanner's head cable to the
Keyboard Wedge cable.
4.
Check the AC input requirements of the transformer to make sure the
voltage matches the AC outlet. A socket outlet should installed near the
equipment and be easily accessible.
5.
Plug the transformer into the side of the female D-type connector located on
the communication cable. Plug the transformer into the AC outlet to supply
power to the scanner.
6.
Turn the PC on.
7.
When the scanner first receives power, the LEDs will flash and the scanner
will beep once. After the scanner performs this start up sequence, the green
LED will remain on for a specified time indicating the laser is on.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements
for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950, the power source should
meet applicable performance requirements for a limited power source.
10
MS860-17 S
CANNER TO A
PC
Figure 1
Advertisement
Table of Contents
