Setting Up The Scanner - Metrologic MS7120 Scanner Setup Manual

Setting Up the Scanner

To set up the scanner, proceed as follows:
Turn off power to the Profit Point Point of Sale (POS) terminal.
1
Unplug the AC power to the POS Distribution Box (D-Box) power supply.
2
Remove the scanner and the Metrologic cable from the shipping box.
3
Note: None of the other parts in the shipping box, including the scanner power transformer,
Insert the phone jack end of the scanner cable into the phone jack connector on the scanner
4
(Figure 1 on page
Connect the DB9 connector on the scanner cable to the scanner port on the POS D-Box
5
(Figure 1 on page
Plug in the POS D-Box power supply to the AC outlet
6
Turn on the Profit Point POS terminal. Follow the instructions that appear on the screen. The
7
Profit Point terminal initializes and begins the POS operations.
MDE-4631 Metrologic® MS7120 Bar Code Scanner Setup · January 2007
will be used with this installation.
6).
6).
Setting Up the Scanner
(Figure 1 on page 6).
Page 5