Table of Contents
Advertisement
NOTE: The manufacturers of this
appliance will accept no responsibility
for damage caused by chemical or
abrasive cleaning .
Let the oven cool down and pay
special attention not to touch the
hot heating elements inside the
oven cavity.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the cooker is cool unscrew and
replace the bulb with another one resistant
to high temperatures (300°C), voltage
230V, 50 Hz, type E14 and same power
(check watt power as stamped in the bulb
itself) of the replaced bulb .
Note: Oven bulb replacement is not
covered by your guarantee .
ASSEMBLY AND DISMANTLING OF
THE SIDE RUNNER FRAMES
•
Fit the side runner frames into the
holes on the side walls inside the oven
(fig. 8.1, 8.2).
•
Slide into the guides, the shelf and the
tray (fig. 8.3).
The rack must be fitted so that the
safety notch, which stops it sliding out,
faces the inside of the oven; the guard
rail shall be at the back .
•
To dismantle, operate in reverse order .
OVEN DOOR
The internal glass panel can be easily
removed for cleaning by unscrewing the 2
retaining screws (fig. 8.4).
Do not use harsh abrasive cleaners or
sharp metal scrapers to clean the oven
door glass since they can scratch the
surface, which may result in shattering
of the glass.
Fig . 8 .1
Fig . 8 .2
Guard rail
Fig . 8 .3
G
Stop notch
Fig. 8.4
23
Advertisement
Table of Contents
