Table of Contents
Advertisement
ANTI-TILT BRACKET
Important!
To restrain the appliance and prevent it tipping accidentally, the anti-tilt bracket
supplied must be fitted according to the instructions below.
To fit the anti-tilt bracket:
1 .
After you have located where the cooker is to be positioned, mark on the wall and on
the floor the place where the four screws of the anti-tilt bracket have to be fitted.
Please follow the indications given in fig. 9.3.
2 .
Drill four 8mm diameter holes for the fixing screws (two in the wall and two in the floor-
see fig.9.3) and insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not damage any pipes or electrical
wires.
3 .
Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied, as
shown in fig. 9.3.
4 .
After attaching the anti-tilt bracket securely, slide the cooker into place . Ensure that the
rear left foot slides under the bracket, as shown in fig. 9.3.
Attention!
When sliding the cooker into place pay special not to trap the power supply
cable in the stability bracket.
ANTI-TIP STABILITY
DEVICE FIXING
Anti-tip
stability device
Fig. 9.3
28
Rear left
feet of range
Advertisement
Table of Contents
