Table of Contents
Advertisement
SYSTEM OVERVIEW
Fire Protection
The fire protection portion of your security system (if used) is always on and will
sound an alarm if a fire condition is detected. Refer to the FIRE ALARM SYSTEM
section for important information concerning fire protection, smoke detectors and
planning emergency exit routes from your house.
Alarms
When an alarm occurs, both the keypad and any external sounders will sound,
and a message at the keypad will identify the zone(s) causing the alarm. In
addition, if your system is connected to a central monitoring station, an alarm
message will be sent. To stop the alarm sounding, you simply disarm the system.
Memory Of Alarm
When an alarm or trouble condition occurs, the keypad displays the number(s) of
the zone(s) that caused the problem, and displays the type of alarm or trouble
(ex. FIRE, ALARM, CHECK). The display remains until it is cleared by entering
the OFF sequence (security code + OFF key) twice.
Phone Access &
If your system includes a voice module it will permit you to access the system via
Voice Response
a Touch-tone phone, either on-premises or by call-in when away. You can
Capability
receive voice messages over the phone regarding system status, arm and disarm
the system, and perform most function commands .
Paging Feature
If the paging feature has been programmed for your system, your pager will
respond to certain conditions as they occur in your system, and display code
numbers indicating the type of condition that has occurred. See page 25 for an
explanation of this feature.
–5–
Advertisement
Table of Contents
