Table of Contents
Advertisement
Exit Alarm Warning
Displays and Sounds
Using the
9
CHIME Key
This feature can be
used only while the
burglary
system
is
disarmed.
EXIT ALARMS
Your system may support and have been programmed for this feature.
When arming, if an exit or interior zone contains a fault during closing at the time
the exit delay ends , the alarm sounder and keypad sound continuously to alert
you that an unwanted alarm can be prevented if you take action:
• If you disarm the system during the entry delay period that will immediately
follow, the sound stops. The keypad displays "CA" (Canceled Alarm) as well as
a zone indication. No message is transmitted to the central station.
• If the system is NOT disarmed during the immediately following entry delay
period, the sounds continue until the system is disarmed (or alarm sounder
timeout occurs). The keypad displays "EA" (Exit Alarm) as well as a zone
indication. An "exit alarm" message will be sent to the central station.
Note:
The latter "EXIT ALARM" conditions also result if an alarm from an exit
or interior zone occurs within two minutes after the end of an exit delay.
In any of the above cases, a second OFF sequence (security code + OFF key)
will clear the keypad display.
CHIME MODE
Your system can be set to alert you to the opening of a door or window while it is
disarmed by using CHIME mode. When activated, three tones will sound at the
Keypad whenever a door or window is opened. Pressing the READY key will
display the open protection points.
To turn Chime Mode on , enter the security code and press the CHIME key. The
CHIME message will appear.
To turn Chime Mode off, enter the security code and press the CHIME key
again. The CHIME message will disappear.
–21–
Advertisement
Table of Contents
