Table of Contents
Advertisement
General
To Assign, Change, or
Delete User Codes
It is recommended that
obvious codes such as
1-1-1-1 or 1-2-3-4 not be
assigned.
Temporary users should not
be shown how to use any
system function that they do
not need to know (e.g., how
to bypass pro tection zones).
Duress Code
SECURITY CODES
At the time of installation, your installer programmed a personal four-digit Master
code, known only to you and yours. This code is used to perform most system
functions, including arming and disarming of the system. As an additional safety
feature, temporary User Codes can be assigned for use by those not having a
need to know the Master code. Note that the Master code remains in effect even
when other user codes are assigned.
IMPORTANT! When performing any of the procedures that follow, do not allow
more than 2 seconds to elapse between steps, otherwise the entry will be aborted,
and the procedure must be repeated from its beginning.
he Master security code can be used to assign up to 4 secondary User codes. It
T
can also be used to change any User code or to remove (delete) any secondary
User code from the system.
To Assign or Change a User Code:
1. Enter your Master code and press the CODE [8] key.
2. Enter the single-digit User Number for whom a code is to be assigned or
changed (User Nos. 3 to 6 may be assigned.)
3. Enter the desired 4-digit code for use by that User Number. The keypad will
beep once when a User code has been successfully entered.
To Delete a User Code:
Perform steps 1 and 2 above and then stop. In a few moments, the keypad will
beep once, indicating that the existing code has been deleted.
This feature is intended for use when you are forced to disarm or arm the system
under threat. When used, the system will act normally, but can silently notify the
central station of your situation, if that service has been provided.
The Duress code may be any 4-digit code assigned to User Number 8.
–10–
Advertisement
Table of Contents
