Table of Contents
Advertisement
SECURITY CODES (Continued)
Duress Code
(Continued)
To Change Your Master
Code
Quick Arming
Ask your installer if "Quick
Arming" is active for your
system; if so, check here:
Phone Module
Ask your installer if your
system includes a phone
module; if so, check here:
To program a Duress code:
Enter your Master Code + 8 + 8 + [desired 4-digit duress code].
The keypad will beep once.
The Duress code must differ from the Master Code or any other User's Code.
To change the Duress code:
Enter your Master Code + 8 + 8 + [new 4-digit duress code].
To delete the Duress code:
Enter your Master Code + 8 + 8, and then stop. When the keypad beeps once it
signifies that the code has been deleted.
1. Enter your Master code and press the CODE [8] key.
2. Enter "2".
3. Enter your new Master code.
4. Enter your new Master code again. The keypad will beep 3 times, indicating
acceptance.
If your system supports "Quick Arming", the "#" key can be pressed in place of
the security code when arming the system. The security code is always required,
however, when disarming the system.
f your system includes a phone module, your installer will have programmed a 2-
I
digit phone access code for your system. Be sure to obtain this phone code from
your installer.
Complete information regarding the use of this phone access feature is provided
in a separate manual entitled PHONE ACCESS USER'S GUIDE , which
accompanies the phone module.
–11–
Advertisement
Table of Contents
