Before Use - Hilti PML 32 Operating Instructions Manual

Laser information plates for the USA based on CFR 21
§ 1040 (FDA):
This laser product complies with 21 CFR 1040, as
applicable.
5.4 General safety precautions
– Check the tool for possible damage before use.
– The accuracy of the tool must be checked after it has
– When the tool is brought into a warm environment
– If mounting on an adaptor, ensure that the tool is
– Keep the laser exit aperture clean to avoid
– Although the tool is designed for the tough conditions
If it is found to be damaged, have it repaired at a Hilti
service centre.
been dropped or subjected to other mechanical
stresses.
from very cold conditions, or vice-versa, allow it to
become acclimatized before use.
screwed on securely.
measurement errors.
of jobsite use, as with other optical instruments
(binoculars, spectacles, cameras) it should be treated
with care.
12
5. Safety precautions