Silvercrest SFS 110 A1 Manual page 12

NOTE
► The bag opening must lie flat on the welding wire
ing does not work properly.
4) Close the appliance lid
wire
lid
5) Press the
sealing process is finished, the red control lamp
NOTE
► You can halt the sealing process at any time by pressing the
The red control lamp
CAUTION – PROPERTY DAMAGE!
If the red control lamp
10 seconds, there is a fault with the appliance.
► Remove the plug from the mains power socket immediately. Do not attempt
to repair the appliance yourself. Contact the Customer Service department.
6) Open the appliance lid
upwards. Remove the bag. This is now sealed at one end.
NOTE
► Ensure that the weld seam is properly closed. A correct weld seam should
be a smooth, straight stripe without any creases.
7) Fill the bag. You must leave at least 6 cm of the bag free up to the edge to
be welded.
CAUTION – PROPERTY DAMAGE!
► Fill the bag so that no food scraps or liquids can leak out during welding
and get into the appliance.
8) If you do not want to vacuum the bag, you can now weld the other, open side.
SFS 110 A1
. The press seal
, to create a smooth seam. Ensure that both corners of the appliance
click closed. If necessary, press them down once again on the markings
and so that the appliance lid
button . The red control lamp
goes out.
by pressing the lid release
presses the bag onto the welding
clicks into place and locks shut.
lights up. As soon as the
goes off.
does not go out after a maximum of
. Otherwise the weld-
button .
and flipping the lid
GB
IE
9