Engineering Mode - LG -510W Service Manual

13. ENGINEERING MODE

13. ENGINEERING MODE
A. About Engineering Mode
Engineering mode is designed to allow a service man/engineer to view and test the basic functions
provided by a handset.
B. Access Codes
The key sequence for switching the engineering mode on is 2945#*#. Pressing END will switch back
to non-engineering mode operation.
C. Key Operation
Use Up and Down key to select a menu and press 'select' key to progress the test. Pressing 'back'
key will switch back to the original test menu.
13.1 BB Test [MENU 1]
Baseband Test
A. LED [1-1]
This menu is to test the indicator LED on top left hand corner of a handset.
• Green On [1-1-1] : Green light turns on
• Green Off [1-1-2] : Green light turns off
• Red On [1-1-3]
• Red Off [1-1-4]
B. Backlight [1-2]
This menu is to test the LCD Backlight and Keypad Backlight.
• Backlight On [1-2-1]
• Backlight Off [1-2-2]
• Backlight value [1-2-3] : This controls brightness of Backlight. When entering into the menu, the
C. Buzzer [1-3]
This menu is to test the buzzer sound.
• Melody on [1-3-1]
• Melody off [1-3-1]
D. Vibrator [1-4]
This menu is to test the vibration mode.
• Vibrator On [1-4-1]
• Vibrator Off [1-4-2]
: Red light turns on
: Red light turns off
: LCD Backlight and Keypad Backlight light on at the same time.
: LCD Backlight and Keypad Backlight light off at the same time.
present backlight-value in the phone is displayed. Use Left/Right key to
adjust the level of brightness. The value of the brightness set at last will
be saved in the NVRAM.
: Melody sound is played through the buzzer.
: Melody sound is off.
: Vibration mode is on.
: Vibration mode is off.
- 98 -