LG -510W Service Manual page 37

E. ADC (Analog to Digital Converter) [1-5]
This displays the value of each ADC.
• MVBAT ADC (Main Voltage Battery ADC) [1-5-1]
• AUX ADC (Auxiliary ADC) [1-5-2]
• TEMPER ADC(Temperature ADC) [1-5-3]
F. BATTERY [1-6]
• Bat Cal [1-6-1] :
This displays the value of Battery Calibration.
The following menus are displayed in order;
BAT_LEV_4V,BAT_LEV_3_LIMIT,BAT_LEV_2_LIMIT,BAT_LEV_1_LIMIT,BAT_IDLE_LIMIT,
BAT_INCALL_LIMIT,SHUT_DOWN_VOLTAGE, BAT_RECHARGE_LMT
• TEMP Cal [1-6-2] :
This displays the value of Temperature Calibration.
The following menus are displayed in order;
TEMP_HIGH_LIMIT, TEMP_HIGH_RECHARGE_LMT,TEMP_LOW_RECHARGE_LMT,
TEMP_LOW_LIMIT
G. Audio [1-7]
This is a menu for setting the control register of Voiceband Baseband Codec chip. Although the
actual value can be written over, it returns to default value after switching off and on the phone.
• VbControl1 [1-7-1] : VbControl1 bit Register Value Setting
• VbControl2 [1-7-2] : VbControl2 bit Register Value Setting
• VbControl3 [1-7-3] : VbControl3 bit Register Value Setting
• VbControl4 [1-7-4] : VbControl4 bit Register Value Setting
• VbControl5 [1-7-5] : VbControl5 bit Register Value Setting
• VbControl6 [1-7-6] : VbControl6 bit Register Value Setting
H. DAI (Digital Audio Interface) [1-8]
This menu is to set the Digital Audio Interface Mode for Speech Transcoder and Acoustic testing.
• DAI AUDIO [1-8-1]
• DAI UPLINK [1-8-2]
• DAI DOWNLINK [1-8-3] : Speech decoder test
• DAI OFF [1-8-4]
: DAI audio mode
: Speech encoder test
: DAI mode off
- 99 -
13. ENGINEERING MODE