LG -510W Service Manual page 14

7. AUTO CALIBRATION
• Connection © Connect to phone
• Connection © Disconnect phone : Disconnect phone.
• Connection © Port setting
• Connection © Connect to Ag8960 : Connect to Agilent 8960.
• Connection © Disconnect Ag8960 :Disconnect Agilent 8960.
• Option © Settings © Gpib state
• Option © Settings © MPL
• Option © Settings © CL
• Option- © Settings © Bin file
1. Connect to phone
2. Disconnect phone
3. Port setting
4. Connect to Ag8960
5. Disconnect Ag8960
6. AGC tab
7. APC tab
: Connect to the phone which you want to measure. This
procedure checks whether the PC is connected to
"Ag8960" or not. If not connected to "Ag8960" try to
connect to "Ag8960". After that it performs sync. procedure
with phone. If the sync. procedure is successful state
column on statusbar changed to SETUP else you should
disconnect phone and try it again from the beginning. All
measurement is performed at state SETUP
: Show COM port setting dialog you can change port
number, baud rate etc.
: Show current primary Gpib state.
: Set max Tx power level used in APC procedure.
: Set cable loss value.
: Set default binary file name.
Picture 1. Buttons and status bar
8. Result window
9 . Band setting
10 . Sync. Button
(button 2 + button 1)
11. Start measure
12. Save result
13. Clear result window
- 76 -
14. Port connection state
15. Retry button
16. Ag8960 connection
state
17. Informations.
18. Current state.