Toshiba e-Studio 5560c Copying Manual page 12

1 BEFORE USING EQUIPMENT
Equipment status indication area
The equipment status indication area shows the following information:
1. Receiving tray indication (
This shows the tray to which copied paper exits.
2. [EXIT TRAY] button (
This is for switching receiving (exit) trays.
3. Drawer buttons (
These show the size of paper, amount of paper remaining in each drawer and the paper type set for the drawer. When
you want to use a particular drawer, press the corresponding button.
The button for the 2 trays of the Tandem Large Capacity Feeder shows the amount remaining in each tray.
If the paper size cannot be detected in this equipment, "
- Is unacceptable sized paper placed in the drawer?
P.11 "Acceptable copy paper"
- Is the gap between the paper and the side or end guides too big?
P.13 "Placing paper in drawers"
If the indication still remains, contact your service representative.
4. [BYPASS FEED] button (
When this button is pressed with paper set in the bypass tray, it will be selected as the paper source.
5. Paper type on the bypass tray (
This shows the type of paper placed on the bypass tray with an icon.
10 BASIC Menu for the Copier Function
1
2
P.36)
P.36)
P.51)
P.37)
P.37)
5
4
3
" appears. In this case, check the following two items.