Antenna Connections; Cable Tv Connections; Remote Control; Inserting Batteries - Toshiba 19LV61K Service Manual

Introduction
Identification of controls (Continued)

Remote control

The instructions in this manual describe the function on the remote control. See the page in
EJECT button
47
TV/DVD button 46
Direct channel selection
buttons (0-9)
27
Numbered buttons (0-9) 31
DISPLAY button 28 55
CH / button
27
SUBTITLE button
54
INPUT button
16
ZOOM button 49
PLAY MODE button
51 52 55
PLAY button
46
MENU button
23
SETUP button
62
PAUSE button
47
CH RTN button
28
SKIP ( ) button
48
REV button 48
FF button
48
SLOW ( ) button
48
TOP MENU button
53
RETURN button 57 62
GAME button
16
*DVD MENU button
Use the DVD MENU button to
display the menu included on
many DVD video discs.
To operate a menu, follow the
instructions in "DVD menu."
53
12
Connections

Antenna connections

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system.
If you are using a cable TV service (CABLE), see page
Combination VHF/UHF antenna (Single 75 ohm cable or 300 ohm twin-lead wire)
Antenna
Antenna
jack
jack
75 ohm coaxial cable
(not supplied)
300-75 ohm matching
transformer (not supplied)
Combination VHF/UHF antenna (Separate VHF and UHF 300 ohm twin-lead wires)
Antenna
300-75 ohm matching
jack
transformer (not supplied)
Combiner
(not supplied)
UHF 300 ohm
VHF 300 ohm
twin-lead wire
twin-lead wire
(not supplied)
(not supplied)
Separate VHF/UHF antennas (75 ohm VHF cable and 300 ohm UHF twin-lead wires)
Antenna
jack
VHF 75 ohm
(not supplied)
Combiner
(not supplied)
UHF 300 ohm
twin-lead wire
(not supplied)
14
for details.
POWER button 22
SLEEP button
28
JUMP button
49
Direct channel selection button ( ) 27
AUDIO SELECT button 54
VOL +/– button 27
MUTE button 28
*DVD MENU button 53
ENTER button
22
Direction buttons ( / / / ) 22
EXIT/CANCEL button
22
46
STOP button
CLOSED CAPTION button 35
SKIP ( )button
48
SLOW ( ) button 48
MARKER button
50
ANGLE button
53
REPEAT A-B button
51
PIC SIZE button
38
15
for Cable TV connections.
Connect the 75 ohm cable from the combination
VHF/UHF antenna to the antenna jack on the back
of the TV/DVD.
If your combination VHF/UHF antenna has a 300
ohm twin-lead wire, use the 300-75 ohm matching
transformer (not supplied).
Connect the UHF 300 ohm twin-lead wire to the
combiner (not supplied). Connect the VHF 300 ohm
twin-lead wire to the 300-75 ohm matching transformer
(not supplied). Attach the transformer to the combiner,
then attach the combiner to the antenna jack on the
back of the TV/DVD.
Connect the VHF 75 ohm cable and UHF 300 ohm
twin-lead wire to the combiner (not supplied).
Attach the combiner to the antenna jack on the back
of the TV/DVD.

Inserting batteries

1 2
Open the battery compartment Install two "R03/AAA" batteries
cover in the direction of the (supplied), paying attention to
arrow. the polarity indicated in the
battery compartment.
Operation
• Aim the remote control at the remote sensor and press control buttons to operate.
• Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5 meters.
Caution:
• Never throw batteries into a À re.
Note:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with
applicable laws and regulations.
• If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with
new ones.
• When necessary to replace batteries in the remote control, always replace both batteries with new ones.
Never mix battery types or use new and used batteries in combination.
• Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended
period of time. This will prevent battery acid from leaking into the battery compartment.

Cable TV connections

This TV/DVD has an extended tuning range and can tune most cable channels without using a Cable TV converter box.
Some cable companies offer "premium pay channels" in which the signal is scrambled. Descrambling these signals for
normal viewing requires the use of a descrambler device which is generally provided by the cable company.
For subscribers to basic cable TV service
For basic cable service not requiring a converter/descrambler
Antenna
jack
box, connect the Cable TV 75 ohm coaxial cable directly to the
Antenna jack on the back of the TV/DVD.
75 ohm
coaxial cable
For subscribers to scrambled cable TV service
If you subscribe to a cable TV service which requires the use of a converter/descrambler box, connect the
incoming 75 ohm coaxial cable to the converter/descrambler box. Using another 75 ohm coaxial cable, connect
the output jack of the converter/descrambler box to the antenna jack on the TV/DVD. Follow the connections
shown below. Set the TV/DVD to the output channel of the converter/descrambler box (usually channel 3 or 4)
and use the converter/descrambler box to select channels.
Incoming 75 ohm
Cable TV
Converter/
descrambler
For subscribers to unscrambled basic cable TV service with scrambled
premium channels
If you subscribe to a cable TV service in which basic channels are unscrambled and premium channels require
the use of a converter/descrambler box, you may wish to use a signal splitter and an A/B Switch box (available
from the cable company or an electronics supply store). Follow the connections shown below. With the switch in
the "B" position, you can directly tune any nonscrambled channels on your TV/DVD. With the switch in the "A"
position, tune your TV/DVD to the output of the converter/descrambler box (usually channel 3 or 4) and use the
converter/descrambler box to tune scrambled channels.
Converter/
Incoming
descrambler
75 ohm
Cable TV
Splitter A/B switch
3
Replace the compartment
cover.
Approx. 5 meters
13
Antenna
75 ohm cable to
jack
TV/DVD
Antenna
75 ohm cable
jack
to TV/DVD
A
B
15