Advertisement
ALL VEHICLES
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Using Metra's
86-5618, pull the factory radio/climate control panel from the dash. Disconnect the audio
system connectors, blower motor switch connector, vacuum hose harness, a/c damper door
switch connector, and potentiometer connector. Remove the panel.
2
Fig. A
Fig. C
Turn the factory climate control dials into a vertical position and pull the dials off. (see Fig. A).
Remove (2) 5/16" hex-head screws securing the temperature and fan control switches and
remove the switches. Unclip the climate control switch and remove the switch. (see Fig. B).
Mount the switches to the back of the Integrated Mounting Kit
supplied. (see Fig. C).
Holding the climate control dials in a vertical position,
head Screws
insert the dials onto the posts of the mounted switches and secure. (see Fig. D)
1
Fig. B
Fig. D
with (2) #8 x 3/8" Phillips Pan-
3
Fig. A
Remove (2) torx-head screws securing the mounting clips to the sides of the factory
radio/climate control panel and remove the clips. (see Fig. A).
with the same torx-head screws. (see Fig. B)
Integrated Mounting Kit
4
Fig. A
ISO HEAD UNITS:
Snap the ISO Faceplate
to the inner lip of the radio opening. Slide the head unit into the radio opening, align the holes in
the head unit with the holes in the ISO Brackets and mount the unit to the brackets with the
screws supplied with the unit. (see Fig. A).
Slide the DIN cage into the Integrated Mounting Kit
DIN HEAD UNITS:
bending the metal locking tabs down. Slide the aftermarket head unit into the cage and
secure. (see Fig. B)
Fig. B
Mount the clips to the
Fig. B
into the radio opening. Attach the ISO Brackets
and secure by
2
Advertisement
