Headlight Switch; Turn Signal Switch; Horn; Accelerator & Brake Pedals - Ezgo RXV GOLF CAR Owner's Manual

OPERATION AND SERVICE INFORMATION
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings.
B
HEADLIGHT SWITCH (OPTIONAL EQUIP-
MENT)
If the vehicle is equipped with headlights, the ON/OFF
switch (3) is located on the instrument panel to the left
of the key switch (1) (Ref. Fig. 8).
TURN SIGNAL SWITCH (OPTIONAL EQUIP-
MENT)
If the vehicle is equipped with turn signals, the switch (4)
is mounted on the steering column (Ref. Fig. 8).
HORN (OPTIONAL EQUIPMENT)
If the vehicle is equipped with a horn, the horn button (5)
is located on the driver's side floorboard; depressing the
button will sound the vehicle's horn (Ref. Fig. 8).
If the vehicle is equipped with factory installed custom acces-
sories, some accessories remain operational with the key
switch in the 'OFF' position.
ALL accessories that do NOT use the accessory wiring
harness MUST be connected to draw from the entire 48
Volt battery pack. A DC to DC converter is required for
accessories that require voltage other than 48 volts to
operate properly.
ATTACH NEGATIVE WIRE
FROM ACCESSORY TO
(-) BATTERY TERMINAL
ATTACH POWER WIRE
FROM ACCESSORY TO
(+) BATTERY TERMINAL
Accessories, including a DC to DC converter, that are
connected to this vehicle and do not use the accessory
Page 6
harness must be connected across the entire 48 volt
battery pack. This can be done by connecting to the two
battery terminals shown in the illustration.(Ref. Fig. 10)
If the accessory requires voltage other than 48 volts a
DC to DC converter must be used to change the voltage
to the amount required by the accessory. A DC to DC
converter is available through E-Z-GO Service Parts.
The Operational Performance Guarantee of 2 rounds
per day shall be void if non-factory accessories that use
more than 1 Amp/Hour of energy per round are installed
on the vehicle
ACCELERATOR & BRAKE PEDALS
With the key switch in the 'F' or 'R' position, depressing
the accelerator pedal (6) starts the motor and will move
the vehicle in the direction indicated on the key switch/
direction selector. This vehicle is equipped with a motor
brake; when the accelerator pedal is released, the motor
will stop. To stop the vehicle more quickly , depress the
service brake pedal (7)(Ref. Fig. 8).

PARKING BRAKE

This vehicle is equipped with an automatic parking
brake; when the vehicle is stopped the parking brake is
automatically set. The parking brake is released when
the key switch/direction selector is in forward ('F') or re-
verse ('R') and the accelerator is depressed. The park-
ing brake is also released when the run/tow switch is
placed in the 'TOW' or
with the key switch turned to neutral ('N').
In the event of a controller failure the parking brake can
be released using the Manual Release Lever located
under the seat on the end of the AC motor on the driver
side of the vehicle. To use this lever, turn the key switch
to 'OFF' then move the manual release lever in a coun-
ter clockwise direction and hold in down while moving
the vehicle. Once the handle is released the parking
brake is activated again.
Use of the manual brake release lever will
release the park brake and may cause the
vehicle to move unexpectedly.

RUN/TOW SWITCH

Before attempting to tow the vehicle, turn the key
switch to 'N' and move the Run/Tow switch to the
Owner's Guide
(on CE vehicles) position