Table of Contents
Advertisement
General Maintenance
The cooling water should be replaced
and/or replenished regularly.
It is recommended to clean the water con-
tainer, pump, hoses and spray nozzle on a
regular basis. For example, place the
pump in a bucket of clean water after the
sawing job and run the machine for a
minute or so. This also guarantees
a longer lifetime of the pump.
When the machine is not used for a longer
period, the pump should not remain in the
muddy cooling water. Cleaning the pump
as described above and leaving it outside
the water container is recommended.
Regularly check the saw flanges for wea
ring out and replace if necessary.
V-Belt Inspection, Adjustment
and Replacement:
The DalTile 1020TS is designed with a power
transmission V-belt. In order to ensure the
DalTile 1020TS operates at peak efficiency, the
V-belt should be inspected monthly, and chan-
ged if the V-belt shows damage and/or excessi-
ve wear.
When a new belt is installed, it should be
inspected and re-tensioned after the first forty-
eight (48) hours of operation.
A. Ensure the ON/OFF Switch is in the OFF
position.
B. Unplug from the power source.
C. Remove the saw blade.
D. Remove the belt guard.
E. Inspect the V-belt for cracks, fraying,
separation and wear. Go to step G if
replacement is required.
F. Check the belt for proper tension. If the
tension T is correct (approx. 1 5/8") go to
step Q.
MAINTENANCE
G. Loosen the motor mounting bolts, if re-
tensioning only go to step M.
H. Loosen the motor adjustment strap.
I. Push the motor toward the front of the
Cutting Head to loosen the V-belt.
J. Remove the old V-belt.
K. Install the new V-belt.
L. Verify the V-belt is seated in the grooves
of both pulleys.
M. Tighten the motor adjustment strap to
remove slack.
N. Check V-belt tension (proper tension
1 5/8")
O. Repeat steps M and N until proper V-belt
tension is achieved.
P. Tighten the motor mounting bolts.
Q. Install the belt Guard.
DALTILE 1020TS OPERATING MANUAL V02/2004R1 PAGE 15
Advertisement
Table of Contents
