Table of Contents
Advertisement
Cutting Straight Edges
DO NOT FORCE THE TOOL! It will do the job
better and safer at the rate for which it was
designed.
Loosen the Adjustable Cutting Guide
retaining knob.
Position the Adjustable Cutting Guide to
desired cutting length.
Tighten the retaining knob.
Place the tile against the Ruler/Stop
and Cutting Guide.
Turn the motor ON.
Verify proper coolant flow on both sides of
the blade.
Perform the cut.
Turn the motor OFF when work is
complete.
Single Step Cutting
(Use only original saw blades as advised by
the manufacturer)
Move saw head down until the saw is
approx. 3/8" below the saw table.
Secure saw head with the knob.
Place the material to be cut on the sawing
table and position against the fixed stop
and eventually the adjustable stop.
Hold the material with two hands while
making sure your hands are free from the
sawing blade.
Push the sawing table forward with control-
led feed so that the sawing blade is easily
cutting through the material.
Multiple Step Cutting
With this sawing process the sawing blade must
be adjusted to a desired cutting depth. The
material can be cut to the adjusted depth by
PAGE 14 DALTILE 1020TS OPERATING MANUAL V02/2004R1
OPERATING INSTRUCTIONS
moving the sawing table forward and bac-
kward. This process can be repeated until the
material has been totally cut through.
Place the material to be cut on the sawing
table and position against the fixed stop
and eventually the adjustable stop.
Position the saw head at the desired height
Hold the material with two hands while
making sure your hands are free from the
sawing blade.
Push the sawing table forward with control-
led feed so that the sawing blade is easily
cutting through the material and move the
sawing table backward in its initial posi-
tion. This process must be repeated until
the material has been totally cut through.
45˚ Miter Cutting:
NOTE: To cut 45º Miters, the 45º Miter Guide
should be used.
Remove the Adjustable Cutting Guide.
Place the 45º Miter Guide on the Saw
Table and tighten the retaining thumb
screw. Position the tile on the 45º Miter
Guide.
Turn the motor ON.
Verify proper coolant flow on both sides of
the blade.
Perform the cut.
Turn the motor OFF when work is
complete.
Advertisement
Table of Contents
