User Card Management - V-tech IP-MR18S User Manual

10. User Card Management:

This section explains how to configure the key fob function on IP-MR18S, The key fob is used
to open the lock. Total 320 key fobs can be registered with one door station. When swiping the
fob to the door station, the distance must be less than 3 centimeter.
Key Fobs must be registered on the Door station that can be used to open the door.
Register the Key Fobs:
All the registered key fobs are called User Cards/User Key Fobs. New fobs/cards need to
be registered one by one to the Door station to become a valid User Card/User Key Fob; and
every User Card/User Key Fob is related to a certain Monitor Address (Flat code).
When the Doors tation is standby, press [#] --> [9008] -->Password([66666666 by default])
to get into the Debug Mode Menu, then Press [1 #] --> [3] Card Manage -->[1] Add Card to get
into the Add Card page. Please see the followings.
1 . A d d C a r d . . .
[ - - - - ]
P l e a s e I n p u t R o o m C o d e
Enter Add Card menu, and
Room Code is asked.
Delete user cards:
Registered User Cards/Key Fobs can be deleted from the Door station,once doing the delete
operation,the card/key fobs can not open the door anymore. They can also be re-registered
again to become a valid User Card/User Key Fob. There are two ways to delete User Cards/
User Key Fobs:
1. Delete by card: show the unwanted card(s) when the Door station is in Delete Card Mode
2. Delete by room number: delete all the registered User Cards related to that room number.
-12-
1 . A d d C a r d . . .
[ 0 0 0 1 ]
S h o w T h e C a r d
Input Room Code
1 . A d d C a r d . . .
[ 0 0 0 1 ]
C a r d N u m b s : 0 0 0 1 2 5 7 8 9
Read the card to be
authorized