Install Range Hood - Maytag UXT5530AAS Installation Instructions And Use & Care Manual

1. Remove the grease filters. See the "Range
Hood Care" section.
2. Remove mounting screws and lateral supports.
A
A. Lateral supports
B. Mounting screws
3. For vented installations:
Depending on your installation, remove either top
■
or rear rectangular vent knockout. If using round
vent, remove top rectangular knockout.
NOTE: Do not remove rectangular knockouts
if installation of range hood is to be non-venting
(recirculating).
Make sure damper pivot is nearest to top/back
■
edge of range hood.
Remove tape from damper flap.
■
NOTE: The exhaust adaptor/damper can be
installed up to 1" (2.5 cm) on either side of the
hood center to accommodate off-center ductwork.

Install Range Hood

If using rectangular vent, attach rectangular damper/vent
■
connectors to the range hood using sheet metal screws.
A
If using round vent, attach vent transition piece
■
(purchased separately) to range hood top using
sheet metal screws.
NOTE: If the wall cap is directly behind the vent
connector, the dampers in the connector and
wall cap must not interfere with each other.
Remove the vent connector damper if they interfere.
4. Lift the range hood up under cabinet and determine
B
final location by centering beneath cabinet. Mark on
the underside of cabinet the location of the 4 keyhole
mounting slots on the range hood. Set range hood
aside on a covered surface.
5. Use / " (3 mm) drill bit and drill 4 pilot holes as shown.
1
8
6. Install the 4 - #10 x
Leave about
and cabinet to slide range hood into place.
B
A
C
D
E
C
B
A. Vertical vent
B. Sheet metal screws
C. Hinge pin
D. Vent knockouts
E. Horizontal vent
A
A. Keyhole slot
A
A. Drill pilot hole
5 / " mounting screws in pilot holes.
8
/ " (6.4 mm) space between screw heads
1
4
¹⁄₄"
(6.4 mm)
9