Voltage Regulator - Buell Blast 2014 Service Manual

HOME

VOLTAGE REGULATOR

GENERAL
The voltage regulator is located under the frame (above swin-
garm on left side). The voltage regulator is not repairable.
Replace the unit if it fails.
REMOVAL
1. Remove seat. See 2.28
11 1
WARNING
To protect against shock and accidental start-up of vehi-
cle, disconnect the negative battery cable before proced-
ing. Inadequate safety precautions could result in death
or serious injury.
2. Disconnect negative battery cable from battery terminal.
CAUTION
When disconnecting the alternator stator wiring, pull
apart the connector by firmly grasping both connector
halves. Do not pull on leads or damage to the wires and/
or terminals could result.
3. See Figure 7-56. Locate voltage regulator connector [46]
behind left footrest support. Disconnect from alternator
stator wiring. Cut cable straps if necessary.
4. Detach charging wire from main circuit breaker.
a. See Figure 7-57. Disconnect red charging wire from
gold post of main circuit breaker.
b. Route charging wire back to voltage regulator.
5. Remove two mounting screws.
6. Remove and discard voltage regulator.
INSTALLATION
1. Apply LOCTITE 243 (Blue) to threads of two mounting
screws.
2. See Figure 7-57. Attach new voltage regulator using two
screws. Tighten screws to 48-72 in-lbs (5-8 Nm).
3. Connect voltage regulator connector [46] to alternator
stator wiring. Cable strap connector halves together.
4. Route Red charging wire to gold post on main circuit
breaker. Secure wire to frame with new cable straps.
5. Connect negative battery cable to battery terminal.
TIghten fastener to 60-96 in-lbs (7-11 Nm).
6. Test charging system. See
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control of vehicle and death or serious injury.
7. Install seat. See 2.28 SEAT.
SEAT.
WARNING
7.13 CHARGING SYSTEM.
WARNING
1
RD
RD
[46]
BK
BK
1. Main circuit breaker (30A)
2. Voltage regulator
3. Stator
Figure 7-56. Voltage Regulator Connector [46]
a0248x7x
4
3
1. Voltage regulator
2. Connector [46A]
3. Red charging wire
4. Screws (2)
Figure 7-57. Voltage Regulator
2004 Buell P3: Electrical
7.15
a0286x7x
2
BK
3
1
2
7-43