Seat - Buell Blast 2014 Service Manual

HOME

SEAT

REMOVAL
1
CAUTION
Use both hands to release tension on the seat latch to
avoid pinching fingers.
You will need to use both hands during this operation to
release tension on the seat latch (located beneath the seat).
a0021aox
1
1. Locating tab
2. Seat latch
Figure 2-114. Seat Latch
1. See Figure 2-114. Push or pull the seat latch toward the
front of the motorcycle with your thumb.
2. Grasp the rear section of the seat with one hand.
3. Lift seat away from motorcycle to loosen from frame.
INSTALLATION
1. See Figure 2-115. Locate tab on bottom of seat.
a0023xox
Figure 2-115. Underside View of Seat with Locating Tab
2-68 2004 Buell P3: Chassis
2
a0022xox
Figure 2-116. Seat Installation
2. See Figure 2-116. Ensure seat is upright. Grasp the rear
section of the seat with one hand and grasp the front
section of the seat with the other hand.
3795
Figure 2-117. Locking Seat Tongue
3. See Figure 2-117. Push seat forward while flexing the
rear section of the seat upward until the tongue locks into
the bracket located on the frame.
4. Push down firmly on the seat
NOTE
You will hear a click when the locating tab and seat latch, lock
together correctly.
11 1
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during operation of vehicle and result in death or serious
injury.
5. Verify seat is locked in position.
2.28
WARNING