Sealed Wheel Bearings - Buell Blast 2014 Service Manual

HOME

SEALED WHEEL BEARINGS

INSPECTION
1. Block motorcycle underneath frame so wheel is raised
off the ground.
a0199x2x
Figure 2-12. Wheel Bearing Inspection
(Front Wheel Shown)
2. See Figure 2-12. Mount a magnetic base dial indicator to
the brake disc with the dial's contact point on the end of
the axle.
3. Turn the wheel through several rotations, then move the
wheel side to side to check for lateral end play.
a. If the end play is less than the service wear limit of
0.002 in. (0.051 mm), bearing passes inspection.
b. If the end play exceeds service wear limit or feels
rough, remove wheel and replace both wheel bear-
ings.
2-14 2004 Buell P3: Chassis
REMOVAL
1. Remove wheel from motorcycle. See
a0200x2x
3
5
6
1. Forcing screw
2. Nut
3. Washer
4. Nice bearing
5. Bridge
6. Collet with ball bearing inside
Figure 2-13. Removal Tool
2. See Figure 2-13. Obtain WHEEL BEARING INSTALLER/
REMOVER (Part No. B-43933) and assemble.
a. Sparingly apply graphite lubricant to threads of forc-
ing screw (1) to prolong service life and ensure
smooth operation.
b. Install nut (2), washer (3) and Nice bearing (4) on
screw. Insert assembly through hole in bridge (5).
c. Drop ball bearing inside collet (6). Fasten collet and
ball bearing to forcing screw (1).
3. Hold end of forcing screw (1) and turn collet (6) to
expand edges of collet.
2.7
2.6 REAR WHEEL.
1
2
4