Maintenance - Set Baking Temperature; Troubleshooting Suggestions - Wells WB1 Owner's Manual
Hide thumbs
Also See for WB1:
- Owner's manual (20 pages) ,
- Operation manual (13 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
CAUTION:
BURN HAZARD
Exposed surfaces of the
waffle baker may be hot to the
touch and can cause burns.
Waffle baker grids are very
hot and will cause serious
burns on contact.
Proper temperature for baking
waffles is 390ºF (200ºC).
Variations in altitude and/or
batter mix may require a
slightly different temperature
for best results.
TROUBLESHOOTING
SYMPTOM
Power cord not plugged in, or circuit breaker
tripped
Will not heat
Power switch off
Internal component damage
Excessive carbonization of grids
Does not maintain
temperature
Internal component damage
SET BAKING TEMPERATURE
Wells WB1 and WB2 waffle bakers are factory set for 390ºF ±5ºF
(200ºC ± 3ºC).
CHECK TEMPERATURE
1. Use a digital thermometer with an oven probe.
2. Place the probe on the lower grid, then gently close the upper
grid.
3. Press the power switch "ON". Wait 15 minutes for the waffle
baker to come up to heat, and for the temperature to stabilize.
4. Read the temperature on the digital thermometer.
ADJUST TEMPERATURE
1. Each waffle baker section has an individual temperature
control. Pry round hole plug from back of that side of the
waffle baker. DO NOT disconnect grounding tether from the
hole plug.
2. Use a thin flat-blade screwdriver to turn the temperature
adjustment dial. Rotate clockwise to increase temperature;
counter-clockwise to decrease temperature.
NOTE: Make small incremental changes only.
3. Allow at least 3 minutes for temperature to stabilize before
making another adjustment.
4. When desired temperature is reached reinstall hole plug.
POSSIBLE CAUSE
9
MAINTENANCE
SUGGESTED REMEDY
Establish main power. Be sure appliance is
plugged in
Turn power switch on
Contact an authorized Wells Service Agency for
repairs.
Decarbonize grids
Contact an authorized Wells Service Agency for
repairs.
NOTE: There are no user serviceable com-
ponents in the cabinet or cooking grids. In all
cases of damage or malfunction, contact your
Authorized Wells Service Agency for repairs.
Advertisement
Table of Contents
