Child Seat Anchors – Latch-Type - Mercedes-Benz 2009 E-Class Operator's Manual

Safety and security
Occupant safety
Anchorage ring
2
Hook
3
X
For safety, make sure hook
attached to anchorage ring
safety catch, as illustrated.
X
Swing the rear seat backrest to the rear
until it engages.
X
Check the rear seat backrest to be locked
Y
in its upright position ( page 316).
Once hook is attached, the child restraint
3
itself can be secured.
X
Install the child restraint system and
tighten the top tether strap according to
the child restraint manufacturer's
instructions.
68
Child seat anchors – LATCH-type
G Observe Safety notes, see
page 62.
This vehicle is equipped with two LATCH-type
anchors (at each of the rear outer seats) for
the installation of a LATCH-type child seat
with matching mounting fittings.
G Warning!
Children too big for a toddler restraint must
ride in seats using regular seat belts.
Position shoulder belt across chest and
shoulder, not face or neck.
has
A booster seat may be necessary to achieve
=
beyond the proper seat belt positioning for children
2
over 41 lb (18 kg) until they reach a height
where a lap/shoulder belt fits properly
without a booster.
Install child seat according to
manufacturer's instructions.
The child seat must be firmly attached to
the right and left side anchors.
An incorrectly mounted child seat may
come loose during an accident which could
result in serious injury or death to the child.
Damaged or impact damaged child seats or
child seat mounting fittings must be
replaced.
Non-LATCH-type child seats may also be used
and can be installed using the vehicle's seat
belt system. Install child seat according to the
manufacturer's instructions.
The LATCH-type anchors are covered with
upholstery blends.
Indicates the position of the anchors
1
Anchors
2
X
Fold the upholstery blend upward to access
anchors 2.
X
Install a LATCH-type child seat according
to the manufacturer's instructions.
A rigid connection between the child seat
and the body of the vehicle is established.