Mercedes-Benz 2009 E-Class Operator's Manual page 236

Controls in detail
Useful features
Operation of integrated remote control
X
Switch on the ignition.
X
Select and press the appropriate
integrated signal transmitter button (2,
or 4) to activate the remote controlled
3
device.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
Erasing the integrated remote control
memory
i If you sell your vehicle, erase the codes of
all three channels.
X
Switch on the ignition.
X
Simultaneously press and hold outer signal
transmitter buttons and 4, for
2
approximately 20 seconds, until indicator
lamp flashes rapidly. Do not hold for
1
longer than 30 seconds.
The codes of all three channels are erased.
234
Programming tips
If you are having difficulty programming the
integrated remote control, here are some
helpful tips:
Check the frequency of hand-held remote
R
control (typically located on the reverse
5
side of the remote). The integrated remote
control is compatible with radio-frequency
devices operating between 280-390 MHz.
Put a new battery in hand-held remote
R
control 5. This will increase the likelihood
of the hand-held remote control sending a
faster and more accurate signal to the
integrated remote control.
While performing step 3, hold hand-held
R
remote control at different lengths and
5
angles from the signal transmitter button
(2, or 4) you are programming.
3
Attempt varying angles at the distance of 2
to 12 inches (5 to 30 cm) away or the same
angle at varying distances.
If another hand-held remote control is
R
available for the same device, try the
programming steps again using that other
hand-held remote control. Make sure new
batteries are in the hand-held remote
control before beginning the procedure.
Straighten the antenna wire from the
R
garage door opener assembly. This may
help improve transmitting and/or receiving
signals.
i Certain types of garage door openers are
incompatible with the integrated remote
control. If you should experience further
difficulties with programming the
integrated remote control, contact an
authorized Mercedes-Benz Center, or call
the Mercedes-Benz Customer Assistance
Center (in the USA) at
1-800-FOR-MERCedes, or Customer
Service (in Canada) at 1-800-387-0100.
i USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any
interference received, including
interference that may cause undesired
operation.