Canon MB2300 series Online Manual page 276

3. Tap LAN settings.
4. Tap Change LAN.
5. Tap Wireless LAN active.
If you do not use the machine over wireless LAN, select Wired LAN active or Disable LAN.
Setting of the Access Point Mode
Specify the settings for the access point mode following the procedure below.
1. Make sure that the machine is turned on.
2. Flick the HOME screen, then tap
Using the Operation Panel
3. Tap Device settings.
4. Tap LAN settings.
5. Tap Other settings.
6. Tap Access point mode settings.
The screen to enter the access point name (SSID) is displayed.
7. Tap the touch screen.
8. Enter the access point name (up to 32 characters).
Enter the access point name when you use the machine as an access point.
9. Tap OK to finish entering the name.
10. Tap OK to finish specifying the access point name.
11. Select the security setting.
Disable
Finishes the access point settings without specifying the security setting.
WPA2-PSK (AES)
Specifies the security setting applying WPA2-PSK (AES). Proceed to the next step when the
screen to specify the password is displayed.
12. Tap the touch screen.
Setup.
276