Table of Contents
Advertisement
Mounting
Orientation
Rigging
Mounting Diagram
Page 10 of 18
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
The LFS-75DMX may be mounted in any position; however, make sure adequate
ventilation is provided around the product.
·
Before deciding on a location, always make sure there is easy access to the product
for maintenance and programming.
·
Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see the
·
When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, such as an elevated platform or a truss.
·
When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The bracket has 13-mm holes, which is appropriate for
this purpose.
·
When power linking multiple products, you must always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
·
The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
·
The double-bracketed yoke allows for surface mounting. When mounting the
product on the floor, make sure that the product and cables are away from people
and vehicles.
Mounting
Clamps
Bracket Adjustment Knob
Technical
(x2)
Specifications).
Safety Cable
Double-
Bracketed
Yoke
LFS-75DMX User Manual Rev. 3
Advertisement
Table of Contents
