Table of Contents
Advertisement
Instruments
Operation
and controls
Malfunction and indicator lamps
Seat belt nonusage warning lamp
With the electronic key in starter switch
position 2, the seat belt nonusage warning
lamp comes on, and a warning sounds for a
short time if the driver's seat belt is not fastened.
After starting the engine, the seat belt nonusage
warning lamp blinks for a brief period to remind the
driver and passengers to fasten seat belts.
Malfunction and indicator lamp in the center
console
AIRBAG OFF indicator lamp
The 7 indicator lamp will light up for approximately
6 seconds when you turn the electronic key in starter
switch to position 1 or 2.
It does not light up if there is a fault in the system.
The 7 indicator lamp stays lit as long as a
TM
BabySmart
child seat is properly installed on the front
passenger seat. It indicates that the front passenger
airbag is switched off.
See page 88 for BabySmart
system.
Instrument
Driving
cluster display
308
TM
airbag and its deactivation
Practical hints
Car care
Warning!
TM
The BabySmart
airbag deactivation system will
ONLY work with a special child seat designed to
operate with it. It will not work with child seats
TM
which are not BabySmart
Never place anything between seat cushion and
child seat (e.g. pillow), since it reduces the
effectiveness of the deactivation system.
Follow the manufacturer's instructions for
installation of special child seats.
The passenger front airbag will not deploy only if
the 7 indicator lamp remains illuminated.
Please be sure to check the indicator every time
you use the special system child seat. Should the
light go out while the restraint is installed, please
check installation. If the light remains out, do not
TM
use the BabySmart
restraint to transport children
on the front passenger seat until the system has
been repaired.
TM
Baby Smart
is a trademark of Siemens Automotive Corp.
Technical
Index
data
compatible.
Advertisement
Table of Contents
