Table of Contents
Advertisement
Instruments
Operation
and controls
Starting and turning off the engine
Starting with KEYLESS-GO
Note:
For improved recognition of the chip card the doors
should be closed when pressing the start-/stop button.
Depress brake pedal during the starting procedure.
Do not depress accelerator.
Briefly press start-/stop button on gear selector lever.
The starter will engage until the engine is running.
If engine will not run, and the starting procedure stops,
press start-/stop button on gear selector lever and repeat
starting the engine.
After several unsuccessful attempts, have the system
checked at the nearest authorized Mercedes-Benz
Center.
Instrument
Driving
cluster display
236
Practical hints
Car care
Turning off with KEYLESS-GO
Stop the vehicle and put the selector lever in
position "P".
Press start-/stop button on the selector lever until the
engine stops. With the driver's door closed the starter
switch is set to the "On" position (starter switch
position 1). With the driver's door opened the starter
switch is set to the "Off" position (starter switch
position 0, same as electronic key removed from starter
switch).
Note:
The engine can only be turned off with selector lever in
position "P". If attempting to turn off the engine while
the selector lever is in any other position than "P" a
signal sounds and the message "SELECTOR LEVER
TO P" appears in the multifunction display as a
reminder to move the selector to position "P".
Technical
Index
data
Advertisement
Table of Contents
