Setting The Control Protocol Of The Projector - Sony VPL-FHZ65 Operating Instructions Manual

Setting the Control Protocol
of the Projector
Change the settings for the control protocol
on the Setup page. Entered values will not be
applied unless you click on [Apply].
1
Click on [Advanced Menu] to display
the buttons for more settings.
Advanced Menu button
2
(a) Set Advertisement.
Advertisement Service
setting area
Advertisement button
Start Advertisement Service:
Set Advertisement to enabled or
disabled. Items for Advertisement are
enabled only when this function is
enabled. The function is disabled at the
factory default.
-Community:
Input the community name for
Advertisement and PJ Talk. If the
community name for Advertisement is
changed, the one for PJ Talk will also be
changed. Only four alphanumeric
characters can be input. The factory
default setting is "SONY." It is
recommended that the community name
be changed from the factory setting to
avoid unnecessary access to the
projector from other computers.
-Port No.:
Input the transmit port of
Advertisement. The factory default
setting is "53862."
-Interval:
Input the transmission interval (minutes)
of Advertisement. The factory default
setting is "30."
-Broadcast Address:
Input the destination of data via
Advertisement. If nothing is input, the
data will be broadcast in the same
subnetwork.
(b) Set ADCP.
ADCP Service setting area
ADCP button
Start ADCP Service: Set ADCP to
enabled or disabled. Items for ADCP are
enabled only when this function is
enabled. The function is disabled at the
factory default.
-Requires Authentication: Set the
authentication for ADCP to enabled or
43