5-40 BRAKES
6. Inboard Pad
Figure 41—Replacing Disc Brake
Linings (Bendix Models)
1. Wheel and tire assembly, refer to WHEELS AND
TIRES (Sec. 3E).
CAUTION: See " C aution" on page 5-1.
2. Position C - clamp and tighten until the piston bot
toms in its bore (figure 43).
• C - clamp.
6. Inboard Pad
7. Outboard Pad
8. Bolt
9. Support Key
Figure 42— Bendix Disc Brake Assembly
Figure 43—Compressing The Caliper Piston
3. Bolt (8).
4. Support key (9) and spring (10).
• Use a brass punch and a hammer to drive the
support key out (figure 44).
5. Caliper assembly.
• Suspend the caliper from the suspension (figure
45).
B-07798