Cable Replacement - GMC 1986 P-Truck Service Manual

Tighten
• Refer to " Torque Specifications" in this
section.
5. Check the parking brake adjustment, refer to
" Parking Brake Adjustment" in this section.
MODELS
P
|+ + | Remove or Disconnect (Figure 19)
• The parking brake must be in the released
position.
1. Nuts (10) and washers (11).
2. Bolts (12) and washers (13).
• Spacers (14).
3. Cotter pin (15) and washer (16).
• Clevis pin (17).
4. Nut (18) and washer (19).
5. Bolt (20).
• Spacer (21).
• Cable (22).
6. Handle assembly.
|+<-| Install or Connect (Figure 19)
1. Cable (22).
• Clevis pin (17).
• Washer (16) and cotter pin (15).
2. Spacer (21).
• Bolt (20).
• Washer (19) and nut (18).
3. Spacer (14).
NOTICE: See "Notice" on page 5-1 of this
section.
4. Washer (13) and bolts (12).
• Washers (11) and nuts (10).
• Nuts to 24 N m (18 ft. lbs.)
5. Check the parking brake adjustment, refer to
" Parking Brake Adjustment" in this section.

CABLE REPLACEMENT

FRONT CABLE REPLACEMENT
(C-K MODELS)
|<~+| Remove or Disconnect (Figures 20 and 21)
• Raise the vehicle and support with suitable safety
stands.
1. Nut (31) from the equalizer (32).
2. Connector (33) from the front cable.
3. Bend retaining fingers (34) and (35).
• Cable from the brake pedal assembly.
4. Cable assembly (36).
• Attach a piece of wire to the cable to help in
installation.
Install or Connect (Figure 20 and 21)
1. Cable assembly (36).
• Make sure all the retaining fingers are completely
through the holes.
2. Cable to the pedal assembly.
3. Connector (33).
4. Nut (31) onto the equalizer (32).
f t
A djust
• Refer to " Parking Brake Adjustment" in this
section.
5. Lower the vehicle.
FRONT CABLE REPLACEMENT
(G AND P MODELS)
Remove or Disconnect (Figures 20, 22 and 23)
• Raise the vehicle and support with suitable safety
stands.
1. Nut (31) from the equalizer (32).
2. Connector (33) from the front cable.
3. Bolts (37) and clips (38).
4. Cable from the pedal/handle assembly.
5. Bend retaining fingers (34).
6. Cable assembly (36).
• Attach a piece of wire to the cable to help in
installation.
Install or Connect (Figures 20,22 and 23)
+ 4 -
1. Cable assembly (36).
• Make sure all the retaining fingers are completely
through the holes.
2. Cable to the pedal/handle assembly.
3. Clips (38) and bolts (37).
4. Connector (33).
5. Nut (31) onto the equalizer (32).
Adjust
• Refer to " Parking Brake Adjustment" , in this
section.
6. Lower the vehicle.
CENTER CABLE REPLACEMENT
|+ + | Remove or Disconnect (Figure 20)
• Raise the vehicle and support with suitable safety
stands.
1. Nut (31) from the equalizer (32).
2. Both front and rear connectors (33).
BRAKES 5-23